|
ICQ# 16388743
|
Configuring
the Linksys EtherFast 4-Port Cable/DSL Router was simple, make sure you have the
below mentioned requirements at hand before you start. Configuration is done
through your web browser and requires the following information from your ISP.
You
open your browser and enter the address to http://192.168.1.1. You
will be prompted with an “Enter Network Password” pop up box. You leave the
User Name empty and enter the default password, which is “admin”. Then
you should see a “SETUP” page from Linksys. For the most part this is the
only page you will need, next to the change password page, which would not be a
bad idea. In
the “setup” page the “Router name” is the name of the computer, in my
part as I am on the @Home network it was my cr22222-a
number, then the “Domain Name” in my case was @Home. Nothing else on
the page I changed. Some people may have a problem and have to “Specify a IP
Address”. I
then clicked on the “Password Tab” and changed the default password to my
own preference.
|
News Updated every 15 minutes, 365 days a year
Reference MadnessPC Monthly Giveaway Page
|
Send mail to merc@merc100.com with questions or comments about this web site. Got news? send to news@merc100.comCopyright © 2000-2001 MERC100.com. Privacy Policy. Most the information contained on this site is copyrighted material. It is illegal to copy in this information without the written consent of the appropriate owner(s). MERC100.com is not responsible for damages that the information on this site may cause to your components / system etc...Logo design by Janne Puonti |